5100's

I am thinking about grtting some of these. Is there anything that ineeds to be done, like with a body lift. Or do you install and no mods are needed?

 

install and no mods are needed. If you set at the 2.5in setting you may run into aligment issues in which case you might want to purchase some aftermarket UCA's but you are fine without them

 

Thanks! If i do get them i will run them at 1.75 or 2 max. I was just making sure that i did'nt have to mod the shifter or brake lines etc etc.

 

Will this raise the rear also or do i need blocks or an add a leaf.

 

Most members avoid using blocks and go with an AAL instead. The ride will be better with the AAL's.

 

Thanks!

 

will running just the 5100's in the front be ok while leaving the rear alone?.....i have a 06 access offroad 4X4 (i have been searching but this is quicker ha!)

 

Yep you'll be fine. i'm running my billies at 2.5 with no lift in the rear

 

if i bought 4 will just those lift my truck,front and back?

 

Only the front 5100's are adjustable with height. The rear 5100's are made to accomodate a rear lift. To lift the rear you can do blocks (not recommended), spindle lifts, AAL, Leaf packs, ect..

 

The rear 5100's wont lift the back?