Aftermarket tonneau cover question

Hey all,

Bought a used tonneau cover made by Redrock4x4 from local whom did not have the clamps to clamp it down to the truck bed.

I contacted ExtremeTerrain and Redrock4x4 themselves and was met with “sorry we’re a bulk distributor/manufacturer and cannot sell installation hardware to you”

I tried Amazon but to no avail. I am looking to see if someone has any thoughts on a clamp kit that I can use on this tonneau cover vs having to pay $300 for a new one just for its installation hardware.

 

Pictures may help.

 

Email them back, for a list of retailers in your area.

 

This

 

I think this is what you need. I assumed it was a hard tri-fold

$34 Kikito Universal Replacement Parts for Hard Tri-Fold Tonneau Cover -6* T-Bolts, Rear Clamp, Front Clamp

https://www.amazon.com/Kikito-Universal-Replacement-Tri-Fold-Tonneau/dp/B09VKXQ1WQ?crid=62LDKSJAKB7P&keywords=kikito+tonneau+cover+replacement+parts&qid=1668891774&sprefix=kikito+tonneau+cover+replacement+parts%2Caps%2C100&sr=8-1

You also need the brackets the clamps attach to that bolt to the internal bed tie down rails. I could not find those.

 

I’ll post some tomorrow.

I will set the cover where it would sit tomorrow Thanksgiving morning and post pictures that way. Sorry for the delay.

 

This is certainly good information to consider when buying a new cover. Seeing that half of the attachment hardware is either plastic or may get lost if you need to remove the cover to free up some space it's nice to know if you can buy replacement parts.
I have the factory hard tri-fold and being only three years old it looks like it's been out in the desert sun for about 15 years. It looks terrible and barely out of 3/36 Toyota told me to pound sand. I'm currently trying to decide if I'm going to replace it or refinish it.

If I replace it, I will certainly set it on fire, video it and send the footage to Toyota.