Anyone in the west valley?

Ah! Gotcha. I have a few friends who are on colors or task from selling/smoking pot so when I hear drug test, its just what I think of.

Department of Corrections, hell you might meet some of my friends in that line of work!

 

Dunno why my post didn't post. Bput to rebuild the clutch peddle assembly and am gonna go get stuck in mud. Anyone down? I need to stay outta the bar and tone down drink for a while. Adam what noise? Check fluid levels.

 

derp cause i post in the az bs thread.

 

^ hahaha.. I'm in chandler so I think your too far away for us to meet up tonight. But I think I'm going to head out towards the Rein Fair and play in some mud.

 

I'm down for some mud!!!

 

like i said, im out herei ngarage rebuild peddle. lets go dude. id prefer close but i know of nothing besides my airport, would you be down for that?

 

How sloppy is it? Nothing too rocky right?

 

How long you gonna be? I was out around White Tanks yesterday but there wasn't much mud.

 

how long where what?

 

Hell where should I meet you? PM Sent

 

Actually I probably know when it happened. I had my sway bar off and took my truck out to the wash between Bartlett Dam Road and Needle Rock. 11 mile run of sand and lots of ups and downs. Got the truck hopping pretty good and at one point slammed the passenger front wheel down hard into a big dip. Hit my tire hard in the fender well and I actually had to get out and check things. It's been wobbly for a bit but it aligns straight as an arrow and the techs didn't see anything bent like a control arm or whatnot. I put my sway bar back on to absorb some of the independent motion. Now, the cv sounds like it has a subtle pulsing grind noise at low speeds and I can feel the front end shimmy just a slight bit. On our last run, I could swear I heard one of the cv joints pop a couple times. I'd rather just swap both of them out and start fresh.

My only other concern is that bearings elsewhere might be affected or something I don't know about. Time to get it on jack stands and start messing with it. Happy birthday to me.

 

wellllll fuck. im not goign anywhere tonight. clutch spring has broken the bushings, and is now jepordizing the entire bracket that holds the peddle. SO, i need to get this fixed.

my cell, 623,206,9853, adam, steve, seth, anyone hit me up, ill be out in my driveway here in avondizzle working on it, its almost all the way broken thgouh

 

Can it be welded?

 

well, the hold that the spring sat in went from being round, to a super torn oval. so maaaybe.

imma clean up the area, and weld/rivet a bracket in.

 

No worries. Maybe tomorrow. I still think we should all get together tomorrow. I just popped in Mallrats, so I'm not going anywhere either.

 

i work 2nd shift now, and with these last two days of rain off, ill work straight till chrismas, and probably another 2 weeks after to catch up.

lets just hope its still super muddy tomorrow so i get off.

 

http://www.tacomaworld.com/forum/1s...aky-clutch-warning-bad-welds.html#post4183388

pics of wtf im fighting with.

 

So what are we doing tonight? How about that one Irish pub place in Arrowhead? It's over by the movie theater somewhere

 

Pub sounds good!

 

That Irish pub is new, and is right off of 83rd Ave and Stadium, just west of 83rd. Right around it is a Bucca di Beppo and a bunch of other restaurants.