Bilstein 5100 and Vehicle Stability Control System

Has anyone received a Check Vehicle Stability Control System message after after installing the Bilstein 5100's? I got that along with the Pre Collision System Malfunction - Visit Your Dealer message.

Got this pulling out of my driveway to take the truck to the dealer for my post shock install alignment. Not surprising, since the truck was obviously out of alignment, but when I got in the truck after the alignment, the message was still there. I Immediately turned around and asked them about it, the guy at the desk put a code reader on it, found no errors, and said the electronics guy had to look at it. Since I didn't have time to wait around another 2 hours or bring it back later in the day, I searched here and found a thread on this. I'm hoping this is the solution, but I'm curious if anyone else has run into this problem after installing shocks.

Here's the thread to the possible solution.

https://www.tacomaworld.com/threads/vehicle-stability-control-system-warning.545186/