1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Bilstein 5100's

Discussion in '1st Gen. Tacomas (1995-2004)' started by rvrbarnacle, Feb 25, 2010.

  1. Feb 25, 2010 at 9:03 PM
    #1
    rvrbarnacle

    rvrbarnacle [OP] New Member

    Joined:
    Sep 26, 2009
    Member:
    #23354
    Messages:
    3
    Gender:
    Male
    So Cal
    Vehicle:
    03 PreRunner TRD
    2003 tacoma TRD pre runner changed out rears already it was a breeze. got the 5100's in the coil over today now the question is the best way to get them lined back into the truck seeing they are taller... drop the A arm possibly, or is there a better safer way? I'm setting them at the highest clip, and as I see it now, I need close to an inch to line it with the lower mounting hole for the bolt to slide through. I'm doing this with floor jacks and the truck on stands...
     

Products Discussed in

To Top