Dash panel with accessory holes

Does anyone know if you can take the dash panel under the Ac/htr controls from a newer tacoma and put it in a earlier model that only has the 2 12v outlets in it?

 

I am about 100% sure you can. There is a thread here in the 2nd gen section where someone asked and another member posted up pictures of it installed. I think the 12v outlets were not the same though and wont go in the new panel without modification or something to that extent is what I remembered reading. Of course now when I try to search for it I cannot find it.

 

Yes it does! I found the thread for you explaining it. Check this thread out:

http://www.tacomaworld.com/forum/2n...012-lower-trim-panel-fit-pre-2012-trucks.html

 

^^yes...i did it on mine a while back

 

Thanks, Now I just have to get one.

 

Mine was $120 at dealership...normally like $200

 

Did you get a used panel or order a new one from Toyota? What did it cost you?

 

You read my mind