1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Extra Connector After Clutch Install

Discussion in '1st Gen. Tacomas (1995-2004)' started by williameub, Jan 30, 2015.

  1. Jan 30, 2015 at 8:04 PM
    #1
    williameub

    williameub [OP] New Member

    Joined:
    Jan 30, 2015
    Member:
    #147543
    Messages:
    1
    Gender:
    Male
    First Name:
    William
    Oklahoma
    So, heres a little background.

    I'm mainly a diesel tech and hardly ever work on anything that weighs less than a small house, but decided to help a buddy out and replace the clutch, rack, and brakes in his 1996 Tacoma. (V6 - 4x4)

    Everything went pretty smooth, but for the life of me I can't figure out where this last small connector plugs into.

    I'm assuming its the 4wd Light indicator, but it doesnt seem long enough to get to the t-case and only has 2-pins if I remember correctly. Its not the Rev. Light Switch or a plug to an O2 sensor...

    Its a 2-pin (maybe... I do know its blue though...) connector - Its late and I'll have to wait till Monday to snap a picture.

    I know its not alot to go off of, but you guys seem to have these things pretty well figured out.

    Thanks,
    William
     
    Last edited: Jan 30, 2015

Products Discussed in

To Top