Fab Fours Bumper Owners?

Anyone else running a Fab Fours front bumper on a 3rd gen Tacoma?

 

I’m running front and rear vengeance bumpers. Here’s a couple of pics. I don’t off-road much I have them more for looks than function. Great customer service. I’m happy with them. I have installed 4 rigid radiance cubes since the pic. Can’t get a pic right now but I put 1 amber and 1 white on each side and wired the white backlight to come on with the DRL & running lights and the amber backlight to work with the turn signal. All four fog lights come on using the factory switch nodal relay needed. I’ll try to get a pic tomorrow.

 

Nice! I’m looking at getting a rear fab fours bumper eventually, really impressed the with the build quality of these things, they seem very sturdy.

 

Found some button red led’s to put in the sensor holes on the rear bumper. They are pretty bright so i’m Gonna wire them to work with the brakes and turn signals

 

If you decide to do it hit me up and i’ll Help with the problems I had. Nothing serious but will save you some time

 

That would definitely be a mod id be interested in too! Keep me posted on that.

 

Will do. Should be finishing by this weekend. Will send pics. If you get the fab fours vengeance rear you may encounter the trailer hitch harness being too short on the truck. If so here’s what you will need

$23 Curt 55384 Replacement Vehicle-Side Custom USCAR 4-Pin Trailer Wiring Harness, Black, 6 x 3 x 9"es

Curt 55384 plug and play and you can use the 4 way plug to wire your button leds to. Gives about 6-8 inches of extension

 

Good to know, look forward to seeing pictures of the leds, I’ll post up some photos once I have the rear bumper installed, it may be awhile though.

 

I liked mine a lot, super solid one piece bumper, install was straight forward. The stock bumper is pretty fragile in comparison with all the brittle clips and plastic. Too bad you lose BSM with any rear steel bumper.

 

*Almost* any. https://www.c4fabrication.com/newup...erland-series-rear-bumper-system-bsm-support/

 

I thought they discontinued it due to liability in regards to BSM functioning correctly. But yes, they’re one of the few if not the only one.

 

They did but likely due to lack of interest. It’s one thing to like a product and another to buy it, but who knows.

 

True that. The sides of the bumper are real bulky to accommodate the BSM sensors. Just throws off the aesthetics imo.

 

Fab fours swing out

 

Any of you need the honeycomb filler panels for the vengeance front bumper? Just pay the shipping and they are yours. I cut them to fit a set of rigid cubes and should have left the bar between the two bars at the bottom. Looks fine though i’m Just OCD and ordered a new set. I have double cubes on each side and only one has to be cut the other clears the honeycomb. You’ll need to paint the ends of the metal where the cuts were made. Let me know. Thanks

 

Bump! See post 16. Can send pic of what they look like with rigid cubes mounted. Hate to throw them away.

 

Gone.

 

/thread