1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

front hub assembly

Discussion in '2nd Gen. Tacomas (2005-2015)' started by LBtaco, May 27, 2009.

  1. May 27, 2009 at 11:40 PM

    LBtaco [OP] Thread killer

    Jan 23, 2009
    Long Beach , CA
    15 Nissan Leaf
    Jetsons mod
    I sent a mail to Timken about some front hub assemblies, since toyota wanted about $600 for both front bearings + spindles & seals (recommended parts)
    I got this back.....

    2WD & 4WD 2003-2008 uses a replaceable bearing Module, which is a flanged 2-row bearing. The entire knuckle is removed, and the hub presses apart to get to the bearing. The Hub spindle is reused.
    BM500007 OE#4357060010
    Part is on order with our OE supplier, due End of September

    oh well, like I said before.. it's not that bad now and no noise. I still have to check my tie rod ends for play as well.
    I know some of you guys just replaced just the bearing and it's a PITA to get it off the spindle, it's cheaper but I don't entirely trust it. I'll wait until sept lol.

    just noticed... 03 to 08???!! WTF?

Products Discussed in

To Top