Getting 35’s

Finally ready for some 35’s I am running a 3 inch suspension lift and wheel spacers of course. How can I avoid a CMC currently running 285/70/17 and off road bumper
I know CMC may be needed but truly don’t want it if there is a way around.
Thanks in advance

 

No way around it. I have the same setup but with 295/75s (34ish) and definitely needed the cmc and pinch weld fold. Also needed to cut the inner finder liners/bumper and a high caster alignment. Still rub when compressed.
Once you feel the difference when driving you might even contemplate regearing.

 

Yeah...

Pretty sure that's not going to happen buddy.

 

You have to do a cmc. And you will have to do a pinch weld hammer. You have to have the right wheel offset. You have to do a lot of things to make them work. It’s committing and will take patience. Know what you’re getting into before putting them on.

read up:
https://www.tacomaworld.com/threads/intro-to-fitting-35s-3-lifts.594309/