help please???

ok so to start out i was putting a head gasket on a 95 jeep cherokee today and first i droped a 16 mm socket behind the motor and it ended up being between the transmission and the trans tunnel but this time i didnt have the vaulve cover on and i was able to stick my hand down there to get it (but it was a tight fit) so later on when im putting the valuve cover on i get to last bolt in the back and drop my 11mm deep socket back there and it went to the same place and i cant get to it nor can i reach it
ive tried to use one of those magnetic teloscoping things( u kno what im talking bouyt?) but that didnt work and i tried toing from under the car to get it but cant i need to get it because i need it to tighten the last bolt and i dont have another 11mm deepsocket to tighten the last bolt

so any ideas on how i can get the socket????

(also ive tried rocking the car to get it to slide off of the trans but that didnt work eather)

 

put a jack under it and undo the trans crossmember, drop the trans down and reach up and grab it

 

seams like a lot of work but mabey

wouldnt the motor mounts keep it from lowering?

 

^^^^^^^^^^^you beat me to it! Good luck!

 

thanks man

that damn jeep is a PITA but not that hard tho

 

hmmmm i think...i have 1 of those but im not shure???