1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Installing Bed Extender

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Windsor1, Jan 6, 2014.

  1. Jan 6, 2014 at 1:44 PM
    #1
    Windsor1

    Windsor1 [OP] New Member

    Joined:
    Jan 6, 2014
    Member:
    #120032
    Messages:
    1
    Gender:
    Male
    Pennsylvania
    Vehicle:
    2013 Toyota Tacoma
    I am trying to install a bed extender in a 2013 Tacoma. Everything has gone well until I got to installing the left and right stanchions. I am having difficulty getting the thinner wedges into the stachions. The instructions say to move the right center stanchion over the right tube by tappng with a rubber mallet....if I am reading this right....the stanchion is to go on the "main" frames of the bed extender ?? How does this prevent the center tubes from coming apart ?? I am confused. Any suggestions? Thanks.
     

Products Discussed in

To Top