Maxxis RAZR AT in E and SL

When I ordered mine, it listed my size or it didn't. I waited until my size was listed and then I ordered them.

 

have most shipped to their home or to a selected shop?

 

I did to their top tier approved shop. It was a pretty seamless experience.

 

Just ordered a set of 265/75/16 10 ply. Shipped to my home. Ill report back when they arrive.

 

All of us LR guys are installing them: https://www.tacomaworld.com/threads/lunar-rock-gen-iii-thread.685645/page-58#post-25894397

 

Just got em mounted w/ the new wheels.

 

Just for anyone obsessing over "will it rub or not":

on my 17" x 8.5 rims with a -10 offset, the maxxis razr AT 811s in 265/70/r17 did rub in the front with mud flaps. Took them off and now everything is solid. Hope to get a couple inches lifted in the future that might let me put the flaps back on.

Edit actually found a pair of cheapo plasticolor mudflaps that are supposed to be super low profile, especially at the mount points (drill yourself). Hoping these work.

 

Damn that looks good.

 

I had mine shipped to my place. Brought wheels and tires in together for install.

These tires are definitely low stock right now. When I ordered mine from SimpleTire, the rep told me they had “very little inventory”. When I had it installed at the shop, the guy there said they’ve had a hard time getting their hands on them, otherwise he thinks they’d sell more of them.

So I would just keep checking.

 

Just to be clear, with your specific setup, the rub was just on the mudflaps?

 

Had them shipped to the house, wanted to put a few more miles on the old tires before installation.

Could have saved a little bit on the mounting cost by prepaying with Simple Tire for a local shop, maybe $20 total.

Tires arrived on different days, but all came quickly. Had a great experience with ST. And love the tires.

 

Yes and at just the top / middle of the mud flaps inside the fender well where you install them. Already ordered some plasticolor cheapos that don't protrude at the install points, hoping those will work until I get more changes.

 

Razrs have been impressing me very much this weekend. Dropped down to 25 psi to start with for rocky Sierra stuff on some OHV routes and they seemed to do great. I did a few small water crossings and got bogged at one point. I was able to rock myself back out, and cleared the mud from the tires pretty quickly. I need to try more mud stuff. But so far so good, really liking them.

 

HikingMano: I have same wheels as you and considering the 265/70/17 RAZR AT XL's. Do these measure close to the 31.8 x 10.55 spec?

 

I’ll measure when I get home later

 

It’s hard to tell for sure with them mounted and inflated, but to me they look to be relatively close or slightly smaller. But again, hard to tell if it’s because the stated measurements are taken unmounted without any compression/deformation. I’m on gravel and not on a flat surface so diameter may be a little more than what’s shown.




edited to add: no idea why pics are posting sideways.

 

Awesome HikingMano, thanks for the info. Ordered the 265/70/17 XL's. Looking forward to new tires and wheels!

 

Hope you like them as much as I do!

 

getting mine put on my SCS sr8s next week. went with p285/70/17