1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

OBDII Emissions test

Discussion in 'Technical Chat' started by SILVER06TRD, Jun 10, 2011.

  1. SILVER06TRD

    SILVER06TRD [OP] Well-Known Member

    Joined:
    Sep 6, 2008
    Member:
    #9035
    Messages:
    83
    Gender:
    Male
    AZ
    Vehicle:
    06 TRD
    de-badged, color matched grill, trd intake, trd short shifter, 3" skyjacker coilovers, rear aal, doug thorley long tube and y-pipe, urd catback, high flow cats, uni-chip, hellwig rear sway bar.
    I'm starting this just as an FYI. I searched around a bit and didn't find a thread about this specific topic. Hope it helps out a bit in case the subject pops up.

    I recently went in to get an emissions test on my 2006 (1GR-FE/4.0 V6), Arizona required after 2006. I was unable to get a test done because the computer reported OBD II system "NOT READY".

    I recently had my battery disconnected and come to find out that it takes 50-100 miles (per the dealer) for the computer to reset. I drove about 67 miles highway and stop and go; went back in to get tested and it passed no problem.

    Anyhow, just as heads up in case someone runs into the same problem.

    -If you're interested, let me know and I can post the read out too.
     
To Top