1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site
    Quick Links: Welcome to my next hell, need suggestions. Rear ABS Connector Wires Broken - Help needed. 5VZ-FE, 3.4L V6, Detailed Post on Performance Problem. Please, PLEASE Offer Informed Input Toyota Oil Filter (Made in Thailand) vs. the competition........ Smittybilt XRC wiring Fuel Filter Replacement now leak. (1st Gen)

OBDII location

Discussion in 'Technical Chat' started by Bodab, May 27, 2010.

  1. May 27, 2010 at 3:21 PM
    #1
    Bodab

    #1
    Bodab [OP] New Member

    Joined:
    May 27, 2010
    Member:
    #37924
    Messages:
    2
    Gender:
    Male
    Could someone please post a picture of the location of the OBDII port on a 2002 Tacoma SR5 4WD Automatic.

    I have been under the dash several times and looked at every angle possible and I cannot find it.

    I need a picture.......Thanks
     
    Bodab, May 27, 2010
    #1
  2. May 27, 2010 at 3:24 PM
    #2
    chris4x4

    #2
    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,690
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Its under the hood. Driver side of engine, attached to the intake runners.
     
    chris4x4, May 27, 2010
    #2
  3. May 27, 2010 at 3:40 PM
    #3
    TacoRan

    #3
    TacoRan Well-Known Member

    Joined:
    May 11, 2010
    Member:
    #36976
    Messages:
    354
    ------
    Vehicle:
    -------
    Drivers side under the dash below the hand brake. I have a brake controller in the way so it is hard to get a picture but if you run your hand down the joint where two pieces of plasitic meet under the hand brake it will lead you right to it.
     
    TacoRan, May 27, 2010
    #3
  4. May 27, 2010 at 3:49 PM
    #4
    TacoRan

    #4
    TacoRan Well-Known Member

    Joined:
    May 11, 2010
    Member:
    #36976
    Messages:
    354
    ------
    Vehicle:
    -------
    Best shot I can get, and this is my first attempt to upload a photo into a post:

    [​IMG]
     
    TacoRan, May 27, 2010
    #4
  5. May 27, 2010 at 3:49 PM
    #5
    chris4x4

    #5
    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,690
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    I belive this is it:

    129_0201_51z+2002_Toyota_Tacoma+engine_bay_view.jpg
     
    chris4x4, May 27, 2010
    #5
  6. May 27, 2010 at 3:57 PM
    #6
    chris4x4

    #6
    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,690
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    The OBD II port isnt there. Its in the pic I posted. On the second gens, its under the dash.
     
    chris4x4, May 27, 2010
    #6
    Wyoming09 likes this.
  7. May 27, 2010 at 4:09 PM
    #7
    TacoRan

    #7
    TacoRan Well-Known Member

    Joined:
    May 11, 2010
    Member:
    #36976
    Messages:
    354
    ------
    Vehicle:
    -------
    I used an Actron hand held autoscanner to check and clear various error codes I've gotten over the years, it won't connect to the underhood port. I swear to you there is a OBD II port on the drivers side under the dash, at least in my 2001.
     
    TacoRan, May 27, 2010
    #7
    Wyoming09 likes this.
  8. May 27, 2010 at 4:10 PM
    #8
    chris4x4

    #8
    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,690
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Interesting. I didnt know one was there.
     
    chris4x4, May 27, 2010
    #8
  9. May 27, 2010 at 4:27 PM
    #9
    Bodab

    #9
    Bodab [OP] New Member

    Joined:
    May 27, 2010
    Member:
    #37924
    Messages:
    2
    Gender:
    Male
    Thanks guys....I have a brake controller in the exact same spot. Upon closer inspection the little bugger is hidden by the brake controller.

    Problem solved.
     
    Bodab, May 27, 2010
    #9
    Wyoming09 likes this.
  10. Mar 15, 2020 at 6:49 PM
    #10
    dricketson6464

    #10
    dricketson6464 Member

    Joined:
    Oct 29, 2019
    Member:
    #309408
    Messages:
    9
    Gender:
    Male
    First Name:
    Douglas
    Vehicle:
    Looking for Tacoma or Tundra
    dricketson6464, Mar 15, 2020
    #10
  11. Mar 16, 2020 at 8:37 AM
    #11
    stu8319

    #11
    stu8319 Well-Known Member

    Joined:
    Sep 18, 2018
    Member:
    #266652
    Messages:
    359
    Gender:
    Male
    First Name:
    Stuart
    Oklahoma City
    Vehicle:
    2018 Tacoma TRD Off-Road in Quicksand

    All vehicles sold from 1996 on are required to have OBDII. You should run to an autozone or something and see if their scanner has issues so you know if it's the scanner or the truck at fault.
     
    stu8319, Mar 16, 2020
    #11
    GSRON and Noch like this.
  12. Jun 17, 2021 at 5:08 PM
    #12
    Mainer2020

    #12
    Mainer2020 Member

    Joined:
    Jan 24, 2021
    Member:
    #353862
    Messages:
    11
    Gender:
    Male
    I have the same issue with an Ancel reader. My Taco is 2002. No link. I'll try the autozone approach.
     
    Mainer2020, Jun 17, 2021
    #12

Products Discussed in

ANCEL AD310 Classic Enhanced Universal OBD II Scanner Car Engine Fault Code Reader CAN Diagnostic Scan Tool, Read and Clear Error Codes for 1996 or Newer OBD2 Protocol Vehicle (Black)
$27.99
To Top