Odd rubbing noise? (HELP PLEASE)

Will brake cleaner on the calipers/brake pads get rid of that?

 

No. The pads are either not seated properly or could just be the pistons on the caliper pushing the pad against the rotor.
Some is ok, a lot is not. Drive it and see if the front wheel hubs get to hot to touch.

 

doesnt ever get hot as far as I know. I’ve driven an hour to get to a dirt road to camp with some buddies, gone in 2wd most of the way and had to switch to 4wd when it got steep and they weren’t hot at all

 

those lug nuts are nice, i need sharp black ones like that

 

Yeah they were I think 60$ or something when I got my new pro comps put on. I like them too! Got them at Big-O-Tires I can tell you the brand if you want?

 

Also I still haven’t totally figured out what’s up yet so if anyone has any suggestions they would be much appreciated

 

Well the same noise didn't present itself while on the jack. At least not in the same way as driving.
My bet is going to be the wheel bearings are starting to fail... and only make the noise when under load. The weight of the truck sitting on them

 

I’m gonna guess wheel bearings isn’t a super expensive fix? Should be replacing them at this mileage anyways though right?

 

How urgent is it that I get them replaced also

 

Might just to get access to the pads. You should hear it lifted though...

 

The noise is starting to die down a little bit. I may take it to a car wash just to spray down the whole frame and get anything out that may be causing a rub. But first I’m gonna take my wheels off up front and see about something being wedged in there.

 

start here
https://www.tacomaworld.com/threads/wheel-bearings-hubs-press-service-4x4-prerunner.537080/

 

Lube the ujoints if theres a zerk

 

U-joints on my driveshaft and stuff?

 

What type of lube should I buy I’m gonna but some grease too for my driveshaft cus the grease on it is looking quite old

 

Yep any zerk fitting on your drive shaft some dont have zerks and need replacing..

https://www.autozone.com/greases-an...voline-synpower-grease-tube-14-1oz/720553_0_0

 

sorry if I sound like a complete dumbass, but what does a zerk fitting look like and would it be beneficial to just get some grease and grease my U joints on my driveshaft?

 

https://www.tacomaworld.com/threads/zerk-fittings.244545/

https://www.google.com/search?q=how...msung-ga-rev1&sourceid=chrome-mobile&ie=UTF-8

 

Yes they need lubed if you havent done that it needs done

 

Alright. Gonna run to the auto parts store and pick up some right now. Should I go for red and tacky for the lube and the grease? Also do I need a certain fitting to pop on the zerk