PO171, PO174: Found Problem, Fix?

hello,

I have an '07 with the supercharger and started getting the system too lean error codes. I think I found the problem(s): an unplugged vacuum hose and a unplugged cable, but I'm not sure what to do with them. I don't see a loose hose or a female end for the plug.

Photos below...

Any pointers?

THANKS!

http://imgur.com/a/CwE7d

 

Welcome to the forum. This is not a big problem, your P0 code both are for lean conditions in both cylinder banks. The vacuum nipple you show in the rear usually has a rubber end cap and it may have dried up and broke off. You can a generic one at most part stores or you can use a short piece of vacuum hose with a bolt in the end to plug it off.
The electrical connector may not be used in your application. You can take the wire and using the length of the wire move around under there and see if it can plug into anything nearby. Here is a link to an supercharger install, you can look at the photos and see if they can help. http://www.tacomaworld.com/forum/technical-chat/101770-how-1gr-fe-supercharger-installation.html

Look at the photos around picture 21 for some idea about the connections and to see the red rubber plug on the vacuum nipple on the end of the supercharger in the area you have highlighted in your picture.
Good Luck.

 

Thanks a lot for the reply. That's really helpful.

Also, I appreciate the welcome to the forum. Now that I'm an owner, I should be spending a lot of time here!