Red Bullet VVTi Solenoids GB (Primary GB CLOSED)

For those wanting some performance out of their VVTi system, these solenoids show some promise. Myself and @SUMOTNK have been pulling some strings and been in talks with Red Bullet Solenoids and have a potential group buy in the works. At the time of this writing there is no limit on how many folks can be in on the group buy, but once the buy is on be aware if you are further down the list you may be limited and have to wait until the next GB wave. Information has changed a bit, but just know that if these work out favorably, then distribution of these solenoids may make it stateside for quick and easy access.

Notable power gains in the mid range power band have been noted, driveability issues have been resolved, and as an unwarranted side effect, fuel economy is higher than before. Your mileage may vary based on usage, and weight of your truck.



Benefits come in form of additional torque under the curve. Low and mid range powerband gets a nice kick from this.




The downside to this as with any performance item comes with the price. However, it's a great replacement solution for those having VVT solenoid issues much like myself which emanate themselves in various ways (intermittent or frequent hard to start issues, cold engine misfire issues, and hesitation at take off from idle or low speeds, or direct VVT related codes)

Couple these solenoids with the tuning power of HPTuners and you have an absolutely STELLAR platform to make the most of your potential power output.

FAQ:

- Will these require I pull my intake manifold or supercharger to replace? NO, just remove your throttle body and slide it to the side.

- How long does it take to replace these? It depends on whether or not your engine is cold, on cold engines I would say about 20-30 minutes at most. On hot engines slightly longer due to the potential burn your fingers and hands factor because of the bolts relative location to the coolant manifold.

Photo below of location:



- Are these plug and play? Is anything else required? Yes it is plug and play, and while nothing else is required, in order to optimize them for maximum effectiveness, I do recommend HPTuners.

- What gen are these for? 2nd gen only. It is unknown if these are direct replacements for the 3rd gen Tacoma at the time of this writing. 3rd gen guys will have to study and research their solenoids on their own in order to know if they are the same part number and design as the 2nd gens.

Pricing as of right now comes in at $300 for a pair of solenoids (2). @SUMOTNK is handling the group buy participants with payment and shipment/ pick up of solenoids, so if any question, feel free to post here or message him. The 1GR engine is single VVTi so only two will be needed.

1. 12TRDTacoma (me) - FULFILLED/ Not part of initial 40 for GB
2. @Jimmy92870 PAID
3. @mulisharydr PAID
4. @ARoman83 PAID
5. @prise
6. @dib PAID
7. @Bfz777 PAID
8. @sf.larry PAID
9. @White lightning boosted PAID
10. @scootter82 PAID
11. @nudavinci64 PAID
12. @henryp PAID
13. @Scott B. PAID
14. @blackenblue PAID
15. @zerotimeouts PAID
16. @Sterling_vH111 PAID
17. @MuddySquirrel PAID
18. @ajohnson PAID
19. @04TacoRunner PAID
20. @Kini PAID
21. @Iceman710 PAID
22. @Athlaos PAID
23. @Shadowhunter PAID
24. @alvinfromhawaii PAID
25. @Supra4x4 PAID
26. @XPOTRPR PAID
27. @MurderedTacoV2 PAID
28. @TheFang PAID
29. @TodayWasTHeDaY PAID
30. @zippsub9 PAID
31. @tinker_troy PAID
32. @Murphinator PAID
33. @NLMOOmar PAID
34. @Hawk373 PAID
35. @1slow4.0 PAID
36. @JacksonTacoma PAID
37. @garciav PAID
38. @Biscuits PENDING
39. @kasnerd PAID
40. @racebug68 PAID
41. @point45 PAID

_________________________________________

CUTOFF as of the time being, a 2nd round group buy is unconfirmed, but the pending list for said group buy has the following members on reserve:

1. @greenEFSI
2. @mk5
3. @TacoTuesday1
4. @AllTacosFloat
5. @Key-Rei
6. @T.Barn

SPOTS ARE RESERVED TO A LIMITED AMOUNT OF 40 AT THE TIME OF THIS WRITING (12/1). MY NAME IS INCLUDED IN THIS GB BUT I HAVE BEEN FULFILLED SO THE LIST CAPS AT 41 as I am not a part of the initial 40. AFTER THAT, THIS GB WILL BE CLOSED UNTIL FURTHER NOTICE. PLEASE SEE PAGE 22 POST 434 FOR LATEST UPDATE.

NOTE: Please see this link for the latest update on current results:

https://www.tacomaworld.com/threads/red-bullet-solenoids-feeler-gb.721327/page-4#post-26155805

 

Me. For at least one set

 

@Torspd

 

Added.

 

Do both sets have to be installed or can I get away with only one set to get the performance boost?

 

https://cdn.shopify.com/s/files/1/0258/5513/1701/files/QS_Technical_copy.pdf?845

More info in the above link on the modified solenoid to help potential buyers decide.

 

Count me in

 

We'll only need one set.

 

You have been added good sir.

 

how hard is it to swap these in ?

 

In the beginning stages of a supercharger rebuild atm. Would def be down for buying the first set. Possibly exhaust side.

 

Will this be beneficial to N/A with the intention of adding SC down the road?

 

Yes, I would think so. A lot of the applications for these modified solenoids are for NA or hybrid engines. Strangely, a segment of the Prius crowd has a favorable opinion on these solenoids.

 

@12TRDTacoma you can add me to this list.

 

Added buddy.

 

So $500 is already the posted sale price. What are you hearing for a discount on top of that?

 

I'm in for a set.

 

I'm definitely in.

 

Will update this thread soon. But I've been working with @12TRDTacoma on where to steer this item and GB.