1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Repairing Bent Fuse Holder Pins

Discussion in '2nd Gen. Tacomas (2005-2015)' started by brandob9, Sep 14, 2009.

  1. Sep 14, 2009 at 1:25 PM
    #1
    brandob9

    brandob9 [OP] Well-Known Member

    Joined:
    Jun 26, 2009
    Member:
    #18937
    Messages:
    248
    Gender:
    Male
    First Name:
    Brandon
    Portland, OR
    Vehicle:
    09 DC Long Bed
    Soundproofed cab, beeps purged, bed lights, extra bed tie-downs and TSB springs.
    Hi -

    In my admittedly ham fisted attempts to install a hard wire for my radar detector, it appears that I've bent one of the pins holding the fuse for my 12v outlets on the interior fuse block. Any ideas for getting it back in line?

    My current leading nomination for a workaround is to add a little solder to the tab of the fuse. I know it's a hack, but I'm not in the mood to tear apart my dash.
     
  2. Sep 14, 2009 at 1:50 PM
    #2
    Stu

    Stu Well-Known Member

    Joined:
    Sep 3, 2008
    Member:
    #8963
    Messages:
    280
    Gender:
    Male
    G'Ville, NV
    Vehicle:
    Taco TRD OR
    Not much yet, got a pretty good sound system w/ my custom sub box. Plan on adding more lights & a tool box.
    Ouch, might try a small screwdriver & bend it back or put a little dab of solder on the fuse to make it a bit thicker (Better check the fuse once it cools, might unsolder the link). Gonna have to go under there eventually tho.
     

Products Discussed in

To Top