1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

replacing rod bearings

Discussion in 'Technical Chat' started by 80s toysport, Jun 13, 2012.

  1. Jun 13, 2012 at 6:42 PM
    #1
    80s toysport

    80s toysport [OP] Well-Known Member

    Joined:
    Sep 13, 2011
    Member:
    #63461
    Messages:
    233
    Gender:
    Male
    First Name:
    Nikolai (Nik)
    kansas city, ks
    Vehicle:
    09 DC TRD off road
    Camper, nerf bars, visors, hood bug gaurd, ABS killswitch, bed light
    Ok guys, motor ran fine before it sat for several years. Put back into my project vehicle and got it started after a few tries. Run and idles fine then all of a sudden i hear a knock when i first step on gas and/or when i rev it up to 2000 rpn. Goes away if i go higher. Pretty sure its the rod bearings but im going to pull the motor back out and take the oil pan off to make sure. I know i should do a full rebuild but then im short on cash (since i got to get tires for the truck in a few weeks) and was wandering if i can just replace the rod bearings while i have the oil pan off if it still looks good and has anyone done this
     

Products Discussed in

To Top