RTMR Schematic

Here's a schematic Post 1

https://www.tacomaworld.com/threads...use-box-group-buy-ends-sept-30th-2015.387403/

Note: After discussions with Jim on the phone, this thread was posted so that Jim could have easy access to the schematic and determine which style switches are compatible with the @Yotamac RTMR set-up.

This thread may be deleted in the future as per our discussion.

 

@Yotamac

Hi Ze,

I bought a RTMR set up from you in the last group buy.

https://www.tacomaworld.com/threads...use-box-group-buy-ends-sept-30th-2015.387403/

I am just getting around to installing it and need to buy switches. I talked to Jim over at OTRATTW and he had a couple of Q's that I couldn't answer. I started this thread so that he could have ready access to the schematic.

1) Is this a J circuit? (I have no idea what he is asking or about electronics)
2) Are the switchbacks set-up for lower independent LED's only? ... or can I go with any style switch? (e.g. upper independent/lower dependent)

... and a Q of my own:

If I run the system independent from the trucks wiring (on anytime), should the 6th switchback/switch be an on/off switch that's set up through the red wire (F6) to power up the other 5 switches' LED's and relays?

Thanks, bro!

Marc

 

Diagrams are for:

5 pin - V1D1J661 - V1D1J66B - V1D1JHHB - V1C1J771

3 pin - V1DAB60B & V1D1B60B

 

These switchbacks are for J circuit switches:

lower independent LED/upper dependent LED

Everything is in order and ordered!

Thanks, Jim!