1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Steering wheel control wire

Discussion in 'Audio & Video' started by slackdaddy2001, Sep 25, 2008.

  1. Sep 25, 2008 at 4:50 PM

    slackdaddy2001 [OP] Active Member

    Mar 21, 2008
    07 Tacoma DoubleCab, SR5 Offroad Pkg.
    I am installing a ASWI-PS which interfaces between my 2007 double cab steering wheel controls and my aftermarket stereo. Does anyone know which wire controls the steering wheel controls. I want to regain this option as I have lost the controls with the installation of my after market stereo. Thanks in advance..
  2. Sep 25, 2008 at 11:12 PM

    mneuls Well-Known Member

    Jul 9, 2008
    Fort St John, British Columbia, Canada
    5100's and dakar leaf 3"lift, Satoshi grill,
    Bilstein 5100's front and back, dakar 3" leaf springs, Westin bull bar, piaa driving lights, piaa replacement bulbs, H/U, 2x10" mtx tt65 subs, 1000w clarion monoblock, Mtx surround speakers. green wire mod. Flowmaster 40, airaid intake. scanguage II.
    there are three wires in the smallest harness. they are in pin 6,7 and 8 of the harness. In my case, I had to put pin 6 to ground, put 7 to the control on the after market adapter, and I ran pin 8 through a 150ohm resistor and also onto the control on the adapter. It was easy to set up and it comes with simple instructions. You'll need a soldering iron and some heat shrink though, for the resistor at least, if not your whole setup, Crimping is for losers.

Products Discussed in

To Top