Tacoma - OVTUNE - VFTUNER - Update Info and Original Development

I ran into the same issue you're having and thought something was wrong, tried
another port and it came right up and recognized it as it should. Been a network
engineer for 20 yrs and this was my work LT so I knew the hardware was good.

 

Tried uninstalling all drivers then reinstalling them
Used all USB ports
Still same issue

 

I try to be patient, but did we get the 'possibilities with ECT / D' part of Matt's comment from a week ago, or did it just not register in my head even though I read it.
I recall he did post the expected dates.
(Still hoping for a gear lock mode, possibly activated by ECT button...)

 

Was going to hold out for the new release but decided I could wait no more. Ordered Tune and cable this morning.

 

He has mentioned it but we are still awaiting more detailed information

 

Did you get it figured out?

 

@OVTune You have said that the 1.05 tune and beyond ,will be available for dongle and dongleless users . Will dongle users be able to STAY dongle users ?
In other words if all the dongle users need is the dongle and a new file , they can use a different /new computer if nessessary for updates for the same truck as long as they have the registered dongle ?

 

No
Awaiting mats reply to my email about a team viewer session

 

dongle users do not have to change to dongle-less for 1.05
I will have more info on 1.05 closer to release.

I've forwarded your issue to the developer, this is a first I've ever seen this error

 

Just my luck
Thanks for looking into it
I’ll start from scratch while I wait
It has to be user error
Fingers crossed

 

I started over and sent you the first code
I should have asked this before sending
Is there a way to clear the dongle because I noticed at the bottom of the guardant page it says “attention a session has already been initiated generation of a new number-question may cause unpredictable results “
I think it’s safe to say I am getting unpredicted results

 

Dang no posts for 12 hrs...

 

Fify

 

So I just got back from the dealer having B0400 done on a friend's truck (he is deployed and asked for me to take care of it for him) After sending the truck back twice, they finally did the TSB 0058-18. During my 12 mile drive back to the unit, I noticed it drove much better compared to B0300 and seemed to have a bit more power. 'Course his is a 2wd so that may be the difference in seat of the pants feel. The transmission learning was still there so I would imagine it is going to learn some old ways but prolly not all. There is no cut out in the shift from 1-2 either.

The take away: Just like Mat said, everyone will benefit from this in 1.05!

 

Waiting for my tunes to be emailed. Nothing to post about

 

I'm on Stage 3 of 4 of installing OVT! I was going to wait until 1.05 came out but... who has that kind of patience?

 

Most days I drive carefree thinking, it really can't get much better than 1.04... you'll enjoy it! huge upgrade from stock

 

I keep forgetting I need to start up my laptop so it won't be all crummy and slow when I go to put the new tune on

 

Screw 1.05. Where are my twin turbos!
Edit- with E85