What Have You Done To Your 2nd Gen Tacoma Today?

nice !!

 

Passed another milestone in my '07...

 

Well I'll tell you, if you rebuild the drum and replace shoes/wheel cylinder/drum. Adjust the brakes properly before bleeding them.

 

looks good see post https://www.tacomaworld.com/threads...en-tacoma-today.6499/page-10296#post-23595103

 

Shoot. I told my wife this wasn't possible, due to my short bed. I also just want an excuse to get an enclosed trailer.

 

I just put these in also.....such a simple idea and product.over priced but they work!

 

A little bit of 75k mile love...

Oil change, freshen up the power steering fluid, squirt the intermediate shaft with rust inhibitor, rotate the tires and dumped some fuel system cleaner in right before the fill up.

 

Put in a new X2 Power AGM battery, the voltage booster chip to get a consistent 14.5 volt charge, and did the big 4 wiring upgrade to 0 AWG wire.

 

I have the same battery, voltage booster is on the way. Can you provide some info on the wiring upgrade, where you sourced the parts?

Thanks!

 

mine come today. the day somebody put this up, my bluetooth earpiece (tiny Jabra style) fell down there while moving. Had to hang up the call rather than go through to the settings on my phone to disconnect the earpiece. Sold.

 

How hard were they to remove? Im thinking of doing mine but didnt know how good they were stuck on.

 

I got the terminals from Amazon:

$14 InstallGear 0/4/8 or 10 Gauge Battery Terminals with Shims - Positive and Negative - for Battery Pack, Car Battery Terminal, Battery Terminal Connectors, 0 Gauge, 4 Gauge, 8 Gauge, and 10 Gauge Wires

https://www.amazon.com/gp/product/B07BSVQLCC/ref=ppx_yo_dt_b_asin_title_o00_s03?ie=UTF8&psc=1
and I got the 0 AWG wire and crimped terminal connectors from a local car audio shop (Long Radio)

 

Two plastic rivets on the bottom of the corner protector were the hardest part. The plastic came off easy. I pulled slow and all the adhesive came off with it.

 

TRD off road's have an actual Tow Hook there on the passenger side and not that tie down.

 

Back in December I replaced the exhaust with a Toyota Catback. I tightened down the flange bolt as much as possible since there is a stop on the bolt. I have noticed a lot of condensation now at the flange. I'm going to replace the flange gasket, bolts and springs. Is there anything else I should do?

 

Did you heat it up or just peel it?

 

Scored an unused bpf skid plate and tow off the FB marketplace for $200! Now to get a license plate bracket from @ACEkraut

 

I just peeled it, but it was 85 degrees out..

 

Nice pickup

 

Nice score!