What Have You Done To Your 2nd Gen Tacoma Today?

I got it for $260 from Amazon. A few places had it for less but they all had it on backorder. You can get the aluminized one for $200.

 

Got bored and put Christmas lights in the bed!

 

gave it a much needed vacuum (crap ton of dog hair all over the back seat lol). then turned around and got it a little dirty again driving out to the gun range (dirt roads+post rain= )

 

Brought it back to Toyota again to balance the tires. I really hate service writers. Trying to tell me I dont know what I am talking about.

 

That is their job, to avoid having The shop pay for anything.

 

Needed some street tires so bought some 16" MM 955s with 285/75 terra grapplers. Been running it since wednesday and am enjoying the road alittle better now. I think the rims look gay, but it's something different for now. lol

 

drilled a few holes in the frame....

 

made a light bar, havent painted it yet

 

I would go with satin instead of matte.

 

Im not gonna waste any money on these.

 

Really should align the All-Pro bumper a bit better. It's digging into your fender flares. Easiest way is to put some washers on two of the six studs used to mount the stock crash bar to the frame.

They are, um, speed holes! Because race truck.

 

Installed Wheeler's SuperBumps today.



Some notes on the tools needed: http://www.tacomaworld.com/forum/wheelers-off-road/67293-wheelers-super-bumps-post6140018.html#post6140018

 

Where's all the rust ?

I saw your other post about shortening the allen wrench , how did you turn it ? With the water pump pliers ?

 

I ordered Weathtech floor mats

 

I wash the truck every two weeks at a touchless carwash with floor nozzles. Rust has been minimal except in areas that where dirt can't be flushed out (such as between the rear axle and stock U-bolt plate).

I could turn the capscrew by hand until snug. To torque it down, I slipped an 8 mm socket over the small end of the allen key and plugged in a 1/4"-drive screwdriver handle as leverage.

 

You mean an 8 mm allen socket like this? It's too wide to fit in the counterbore in the bumper.



The 8 mm allen key is included with the SuperBumps, so I had no qualms about cutting it.

 

I have.......possibly blown a seal on my Icon coilovers. My passenger side is leaking shock fluid from the bottom of the resi. Who knows of the cheapest and fastest place to get it rebuilt?

 

I finished my aux fuse box install today, no more hot fuse issues with my off road lights, plan is to add bed lights and under hood lights in the future..

12 slot blue sea fuse panel mounted in a hammond heavy duty project box, protected with a blue sea panel mount 100 amp breaker. I used 1/4" plexiglass for the mount bracket...

 

^ That is very clean. Nice job.

 

Nice