What Have You Done To Your 2nd Gen Tacoma Today?

I did the same! Amazing fit and finish

 

Put a truxedo roll up bed cover on looks great easy install

 

put a for sale sign on my factory 1-piece colour matched tonneau cover... time to fab up my rack.

 

does anyone have a toolbox and rack (baja rack) combo in their truck? looking for different ideas for orientating mine.

 

I love mine. Looks great, and install was simple. Only place where I wouldn't call the fit "amazing" is the corners where the back of your knees hit between the black and grey. You have a little pocket of air there too?

 

Built and installed an ARB Bed Rack with Hi-Lift mount and a locking, double Jerry-Can holder.

 

Drained Front/Rear diff and Xfer case and filled w/ 75w90 Mobil1 Synthetic.....damn that rear diff fill bolt was on good....

 

Today was a throttle body cleaning. Wow was that nasty. 136k miles of oil mist I assume. Black goo was so thick I could barely see any light through where the plate was cracked open.

Maybe that'll help my cold start issue - it would crank slow, fire, stumble, and work up to idling at 1200 rpm even if the engine is 10 degrees F. I know it's still learning but twice today it idled at 1500 cold without the air injection pump running, and it cranked over faster than usual, so that's some good signs. Still has that rumblingly-low 650 rpm warm idle though.

 

Ordered a set of N-Fab rock rails and steps. Before you all start in on me, I know they're not real sliders, but that's OK, because I'm not really going to go off-roading. I love the look and the bolt on steps give my wife the leg up she needs getting into the truck.

 

Installed heimed uppers, new uniballs, and got an alignment finally. ( Caster raked out on purpose)

 

Ordered BAMF sliders from JLee in August. Haven't had the opportunity to put them on until recently. It was a great Christmas day project for the father-in-law and me. Thanks Jerry, they exceeded my expectation, very well made.

 

Did a APE install

 

Put on NFabs and bull bar.

 

Very Nice!!!!!, I think I will pick up a set, how hard to install? Thanks

 

I picked up a 6'x12' uhaul trailer and started loading up for my move from Phoenix, AZ to Huntsville, AL.

 

Install took about an hour, covers just slide on, then clip across the bottom the keep them tight. Looks seamless when finished!

 

Got new spindles today!

 

Nice i want that

 

Went driving in the Alaskan cold

 

What fluids do you use in Alaska? I just picked up some Washer fluid and it was rated at 0º...