What Have You Done To Your 2nd Gen Tacoma Today?

The wife hooked me up

 

What size lift and tires do you have?

 

holy sh*t!! so what color was your truck before this paintjob?

 

285/75/r16 Nitto Trail Grapplers

And this lift

http://toyteclifts.3dcartstores.com/3-lift-kit-with-Bilstein-5100-Height-Adj-Coilovers_p_364.html

 

I don't get it I just see a mud pit?...

 

..Shopping cart dent mod...

 

Does anyone happen to know a good way to attach a recovery point to the back of our trucks w/o a hitch?

 

Hitch bolts to the 6 bolts (3 on each rail) that secure the center bumper bracket.

The whole assembly is pretty stout, but it's covered with the beer-can-like bumper with no access.

You could replace two of the bolts on one side with longer (SAE Grade-8 or higher... Metric would be a grade-10 I think?) bolts and attach there.

 

Nice, how do you like the ride? Once these 265s wear down I may end up doing that lift with some 285 all terrain bfgs.

 

They're pretty good on the road there is a bit of extra road noise but it's not bad at all imo. They were super good in the mud today too, I had to pull a F-350 today out in reverse and it slipped a bit and then bit in and he came right out.

 

Today was led license plate lights then touch up bumper and then relocate rear view mirror...thanks for a great product ImMrYo

 

I'll take a look tomorrow thank you.

 

Did a little shopping on the kijiji classified

 

Carrier bearing drop, Emergency brake relocate, drove it, carrier bearing drop again, drove it still can't get it right. I keep adding a washer until all the drive line vibes are gone.

 

Bought an ARB front bumper and a 4X Innovations rear! Booyaw!!!

 

Are you sure it isnt coming from the front end? When you put the truck in to 4WD, does the sound go away?

If so, it's the front needle bering.

http://www.tacomaworld.com/forum/2n...nt-differential-bearing-vibration-thread.html

read the 'UPDATE!' on the first post.

Hope you can get that vibe fixed.

 

On way home got gas, and used the windshield cleaner/ squeegee to clean the sand/salt/filth mixture off my license plate cover. Can't wait till its warm enough to rinse this crud off.

 

ummmmmm I feel like I should whisper this but pre runner good sir

 

Maybe you should put that in the profile good sir.

 

Today I removed my front mud flaps. I know it's not that exciting but I've already rubbed the mud flaps and I'm currently in a city. So I figured time for them to go. As far as trimming them I haven't seen any photos, and at the same time it gives the front end a better look with them off. I'll post photos tomorrow after I wash her at work.