1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Would anyone recommend these axle shims?

Discussion in '2nd Gen. Tacomas (2005-2015)' started by DestinTaco, May 20, 2011.

  1. May 20, 2011 at 7:18 AM
    #1
    DestinTaco

    DestinTaco [OP] Well-Known Member

    Joined:
    Mar 28, 2011
    Member:
    #53875
    Messages:
    96
    Gender:
    Male
    Destin, Fl
    Vehicle:
    2011 Silver PreRunner Off Road DC SB
    Challenger tube step, OME 884 Coil, 2" AAL, Weathertech vent visors
  2. May 20, 2011 at 7:20 AM
    #2
    especk

    especk Nothin' Special

    Joined:
    Aug 21, 2010
    Member:
    #42041
    Messages:
    2,449
    Gender:
    Male
    First Name:
    Erik
    Redding, CA
    Vehicle:
    2010 Tacoma Reg Cab 4x4
    3" OME lift with 885 coils on nitrocharger 90000 shocks with 5mm trim packer on driver's side, TC UCAs, Rear OME Dakar leafs with nitrocharger shocks, All-pro U-bolt flip kit and 3* Toytec shims, extended rear brakelines, 16" Raceline Rockcrusher 887 wheels with 3.6" backspacking, BFG KM2 305/70/16 tires, Doug Thorley header, Doug Thorley catback exhaust, Volant CAI with ram air, Weathertech floor mats, Kicker 12" sub, Kenwood 500W RMS amp, Relentless Fab front and rear bumpers, 4.88 gears, custom flatbed with swing out tire carrier
    thats what i have. seems to be good quality and help with the vibes too
     
  3. May 20, 2011 at 7:21 AM
    #3
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    106,158
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2013 Rubicon Unlimited,
    4.10 gears, sliders, and lots of buttons.
    Before you do the shims, make sure the U bolts are torqed to spec. 3* is a bit too much. See if you can find 2* shims.
     
  4. May 20, 2011 at 7:21 AM
    #4
    98tacoma27

    98tacoma27 is gooder 'en chicken Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    49,848
    Gender:
    Male
    First Name:
    Ben
    Beech Creek
    Vehicle:
    05 Tundra SR5 (+250k AND COUNTING), 88 SR5 PU (SOLD), 98 TRD OR (CRUSHED)
    5100's all on fours
    Those seem to the choice shims of the board.
     
To Top