LED Lighting Conversion

Awesome! Thanks for your help!

 

I’m trying to find which fuse is linked to the interior lights. The abbreviations on the fuse panel are unclear. Owners manual doesn’t give any info on what they stand for either.
Any suggestions?

 

I found this thread, they specify location of 3nd fuse box. Good luck!

 

OK, but there wasn’t a link provided to the different thread.

 

Turns out I didn’t need front resistors at all. I replaced front and back turn indicators with Philips LED and only needed resistors in the back. I used

$17 Philips 18957B2 21W Vision LED CAN-Bus Warning Canceller, 2 Pack

Philips .

 

So sorry! Here you go

https://www.tacomaworld.com/threads/help-locating-fuses.398716/

Post 10 or so

 

Please update how did you make out.

 

Glad that your VLEDS working without issues, if you get a minute can you point to which LED bulbs you used? My Cement TRD PRO should be here in a couple of weeks really want no issues with LED replacements. Thanks.

 

Once these are in line, what will happen if you go back to incandescent lights ?

 

No idea man lol

 

So, your link to the rear turn signal bulbs, says out of stock, but they're white, I found same brand red LEDs, so I'm thinking they are similar use. Can you verify once again since it's been over a year now, that you do not have hyperflashing with your turn signals, and that you did not use any load resistors? Thank you.

 

Just got my resistors in today from Amazon. Since it came in a pack of 4 I guess I should get red leds for the rear turn signal...which are the best to go with? Links would be great!

 

The fuse panel under the dash has the dome light 7.5 fuse. I was looking at the fuse box under the hood.
All the lights came back on after replacing the fuse. Thanks for the help.
*Ironically, my girlfriend needed to pick up a booger from her nose and said the LED lights shined up her nostrils better than the other bulbs!

 

Okay guys which wires do I splice?? This is the front driver side turn signal. I read 1 & 3 are the ones to tap into but don't want to mess it up.

 

Does this also apply to the front turn signal wires? There are 3 wires numbered. Do I splice 1 & 3?

 

You don’t have to put resistors in the front. Just the rears.

I used these

Philips 7443 Intense Red Vision LED Stop/Tail Light, 2 Pack

Philips 7443 bulbs.

 

And because of my OCD tendencies, I had to get matching Philips WY21 Amber LEDs for the front. Unfortunately they don’t sell them in the US. I had to buy mine from a Japanese seller.

 

I’ve tried several in most slots, different numbers of LEDs per bulb to get what I wanted intensity wise.

I used the shop by vehicle as a 2016 Off-road which worked fine.

5K for interior and 6k for exterior. I prefer 5k, perfectly white and awesome CRI, but stock exterior have a bit of blue/purple so went 6k to be closer to a match.

Did the long life 194. And the Festoon you want is the 29mm, I want the 24 led one which is on preorder. Have the 12 led one in there now and it’s not bright enough for me.

I have the newest reverse lights and brake/turn signal bulbs ready to go in, the HO ones.

Waiting on V6 Triton pre-order for front turn signals.