What Have You Done To Your 3rd Gen Today?

Wife helped lube my ball joints today. Nice to have her home and bored.

 

Looks like we all better buy a nut rivet gun since Bob has one. Perusing Amazon now.

 

Post #54.

https://www.tacomaworld.com/threads/switch-wiring-help.481521/page-3

I believe the green wire on the back of the cargo light, is the illum wire also.

 

Women are good at lubing ball joints. Some are better than others.

 

I’m fortunate to have one that likes to learn.

Start slow and easy, then pump hard enough until it starts to ooze out, and finish with just tight enough screwing.

 

Painted some chrome.

 

Yeah you did. I have an Undercover lid and there are two options with/without rails. The rails are completely covered and useless. Should have removed the rail and went with the "without" model and made my own bracket. But would'a, could'a, should'a... Maybe I can find a rail and create a dual mount or something

 

You'll make it work! If your rails are in the factory position this mounting system is well below the rails and the jack as mounted shouldn't interfere with their use.

 

In a few months, I’d love to see another picture of this. I use those zip tie mounts everywhere, but I remove the foam tape and use black silicone to mount them. I’m wondering if I’m just waisting time doing that.

 

What hood struts are those installed?

 

I'm guessing you're spot on with the silicone. The adhesive on those zip tie mounting pads at least in my experience has a tendency to release when subjected to heat. Genuine 3M (not the cheap Chinese knock off stuff) tape might hold up to the heat but I've found that the foam adhesive normally found on those pads do not.

 

Got bored today at work and wired up a tuffstuff air compressor for the tires under the hood.

 

265/75r16 duratracs load c are 6ply radial.

 

Got my bed mat installed from Amazon

Nothing big but got my wheels and tires mounted and balanced and then got some gas

 

Sticker!! My truck feels faster now.

 

Thanks for the info.

 

Thx homie they are 285/70/17

 

Added some quick fist mounts and acouple accessories.

 

I have a 3amp fuse on mine and I use a hood pin to ground it. Mine are Matt Gecko also

 

Haha Thanks. It was alot of work for sure. Glad its over.