2011 Tacoma Pre-runner Wheel bearing replacement

I did some research before tackling my front wheel bearing. Most of the stuff I found on the web was for 4wheel Tacoma's so I thought I would put something together and include a few links to help others out that have a 2011 4X2. It was my first time doing a bearing on this truck (105K miles). It took about 45 minutes for one side. Thanks everyone for posting information and allowing me to do this on my own. I bought the complete hub assembly from forum member nj636. It comes turn key for ~$275.


1. Jack front end off the ground and secure safely/properly (leave key in ignition in ACC position)
2. Remove the lugs and tire (21mm socket)
3. Turn rotor so that you can access the two caliper mounting bolts (17mm)
4. Remove bracket that holds ABS sensor/brake line (12mm)
-Note- you can remove the abs sensor if you want (10mm)
5. Remove two caliper bolts and pull caliper off rotor (hang caliper with support strap or bungie)
6. Remove rotor (if stuck, check link to remove https://www.youtube.com/watch?v=SDN6pnhExC0 )
-Note- My truck doesn't have a spindle nut!!!
7. Remove 4 hub assy bolts (17mm wrench)
8. Pull out old hub assembly by walking it out or light taps with hammer while pulling (rotor backing plate will come off as well-pay attention to orientation)
9. Clean out hub cavity and install new hub assembly (Reverse the order/operation from steps 8-1)
10. View the links below to find torque specs and get an idea of what you're in for.

https://www.tacomaworld.com/threads...te-save-custom-built-available.288055/page-90

https://www.tacomaworld.com/threads...ce-front-wheel-bearing-2nd-gen.189356/page-17

https://www.youtube.com/watch?feature=player_embedded&v=BVuM8iVO6u8

https://www.tacomaworld.com/threads...-complete-save-custom-built-available.288055/