Adding dash clock to 15 Tacoma

Hello all. I've searched all around and haven't found any wiring diagrams that would work for me. I'm trying to add the factory clock in the hazard switch panel to my 2015 Tacoma trd sport. If anyone knows what additional wiring, if any, has to be accomplished I would appreciate any input (and pictures would be greatly appreciated as I am novice at electrical at best). Thank you.

 

Most members switch it out with the panel with the clock in it from a '14 . Plug and play that way. Not sure if you can buy just the clock separate.

 

Well I'm trading a non clock unit for one with a clock. If I had the new harness wouldn't I still have to run the missing wires to power the clock though?

 

do you have a link on this?

Last I heard, this was NOT plug and play.

 

No I don't have a link but it's been discussed on here were folks switched them out with no problem. It was with a '14 & a '15.

 

hmmmm okay...

 

I'm trying to find were I read it.

 

Apparently there interchangeable. I've seen this posted more than once. It should work.

 

Patiently waiting hopefully you can find it.

 

I don't have the clock unit yet so I can't say for sure but I hope so.

 

No luck digging it up. Sorry!! You should be fine.

 

Would be nice

 

https://www.tacomaworld.com/threads/does-anybody-miss-the-manual-clock-in-the-center-dash.387498/
Here's the one I have in mind.

 

What??!! No clock on a 2015...

Could be that Toyota was trying to avoid a countdown to the 2016.

 

That's the one I found but the wiring at the fuse panel in the pictures is different than mine.

 

Yeah its not plug and play, 2 wires need to be added according to the diagrams in the other thread, I have been wanted to add the clock myself.

 

Thanks for the clairification. From what I read in other posts I was convinced it was plug and play. Thanks.

 

In that case does anyone know what the wiring diagram for the 15 would look like? I've seen the above listed threads diagrams and although the wire type, (tail light, battery, dome light, etc) may be right, the position of it under the dash isn't between those pictures and the 15's.

 

Correct, the clock had been blanked out with a "Tacoma" logo. 50 cents saved x 160,000 trucks per year...



Common practice with American-brand vehicles - clock is shown in the radio only.

 

I have a 2015 and just did the swapover to a hazard switch w/clock. I bought a hazard switch w/clock assembly off of ebay for $95. If you want the clock to have white numbers and you want the hazard button to be black instead of silver make sure you get P/N 84332-04100 which is off of a 12-14 tacoma. I bought 2 terminal repair wires p/n 82998-12690 online from toyota dealer for about $35 shipped. There are 2 wires missing for a 2015. The battery and ACC. I just tapped into the radio battery and ACC circuit because it was right there. I have a entune plus non nav non JBL radio. The repair wires get plugged into pins 13 & 14 on the hazard switch assembly connector. Pin 13 is constant 12v and pin 14 is ACC. I ran pin 13 on hazard switch to pin 4 (Diagram says blue w/yellow stripe but mine had white wire w/blue stripe)on the radio connector that has 10 pins. Then I ran pin 14 on hazard switch to pin 3(grey wire) to the same radio connector. Check pins 3 and 4 with a meter to be sure. I used wire taps to connect the wires. Took about a hour and works great.