Rotopax on KBvoodoo 10” rack

Not sure if this is the appropriate section, if not someone point me in the right direction. I recently installed the KBvoodoo mid height long bed rack and ordered some goodies to go on it. I received a set of rotopax 2 gal fuel tanks today (mounts on the way) and I am concerned about clearance from the bedside. Does anyone have pics of rotopax mounted on this rack/pics of the install? Any help is appreciated

 

Hey @Buckwheat893 , in case you were still looking for references, I saw this in another thread: https://www.tacomaworld.com/threads/kb-voodoo-bed-rack.414449/page-13#post-14317166

@KB Voodoo might have additional insight and/or pictures

 

Thanks man! I got the mounts in and ended up having to drill holes higher on the rack to clear the side of the truck, but it all turned out good

 

No problem. Did you notice any problems if you have a RTT on top of it as well?

 

Nope, I got lucky though. I was an idiot and drilled the holes and mounted up the rotopax before my RTT arrived but luckily the edge of the tent when centered on my rack doesn’t extend all the way to the top of the rotopax. I did have to mount the tent where it folds out on the passengers side as the base would have hit the pax if it folded out towards drivers side. With the maxtrax mounts from KBvoodoo the tent clears them no problem

 

hi I know old thread, but was curious if u had a pic of ur setup where the tent clears the maxtraxs? Thx

 

Awesome thanks so it deployes with no problems and you’re able to climb up into the tent?

 

Super helpful ! Thx a lot!