1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Switches, bed lights, question

Discussion in '2nd Gen. Tacomas (2005-2015)' started by stormyday, Apr 3, 2009.

  1. Apr 3, 2009 at 3:33 PM
    #1
    stormyday

    stormyday [OP] Well-Known Member

    Joined:
    Mar 13, 2009
    Member:
    #14641
    Messages:
    146
    Gender:
    Male
    Morganton, NC
    Vehicle:
    14 Taco Double Cab Pre-Runner
    I planned on putting LED's in the bed and under each door in my truck. I ordered a couple of these switches, but they do not fit (or without modification. I contacted oznium and let them know). I found this post (#359) and I am going to try to follow it.

    Now my questions is that in the process of removing the blanks, one of them had a wire harness connected to it. I noticed through the site that several tacos were pre-wired for fog lights. This harness was not on the blank they said and I checked and cannot find any wiring at all for fog lights on mine. The harness I found is in the power inverter blank. So what is the harness for?

    [​IMG][​IMG][​IMG]



    [​IMG][​IMG][​IMG]
     

Products Discussed in

To Top