Who all is running aftermarket front bumper and no issues with TSS?

Pelfreybilt 2nd gen bumper
2.7" suspension lift + 32" tires + 2020 grille swap means radar is 3.6" higher than stock. TSS works with no errors.

 

Picture you can post?

 

Go read the signature lines of some of the posters in the OVtune/vfTuner threads. They have the software to do this and would be happy to help you...might cost a few beers or something. Plus you can download the program and do it yourself. It's the same thing the dealers use.

 

Good call-- My friends buddy in Long Beach does them. he did his OVtune for 100 bucks. Normally charges 250. Too bad I'm in Texas. But then again a 30 rack is cheaper than 100 bones

 

I want a quote! Send me a PM if you don't mind.

 

Pictures to follow... CBI Baja front bumper (T3 with low center hoop), stock off road grill, and TSS working good. It worked for the short time I had the bumper installed on stock suspension. However, damn did that feel like the truck was swinging a hammer around when taking a turn.

Lifted about 1.5" rear, 2" front with 6112 and 650lb springs, which handles the weight lot better. TSS still working after about 2 weeks and a few hundred miles of use.

 

I want to do this bumper as well but don't want to mess up the TSS. Can you let me know the results?

 

CBI T3 mid hoop (baja) still working fine with TSS. So far no issues at all after ~3 months and 2k miles. I redid the zero pt cal for VSC recently, basically just because I got TS working.

I would say go for it, lifting front without something like rear aal is probably more likely to piss off the sensor due to zero pt. The bumper is fine on stock OR grill TSS.

I cut but recently saw some replacement bumper caps that basically fill in that little section of bumper you normally keep, something to consider. Would still have to cut the fender flare.
https://www.tacomaworld.com/threads...ements-where-do-you-cut.726392/#post-25878795

and overdue pics