Anyone have tryed this spindles?

http://www.ebay.com/itm/Toyota-Taco...itu=UCI&otn=4&ps=63&clkid=7696867375199935876

Thanks for looking....

 

BLOCKS! RUN FOR YOUR LIFE!

 

The spindles don't look too bad, but a 2" block in the rear is just asking for problems.

 

You get what you pay for, if you want a spindle that wont bend in half, then buy one that wont.

Edit: That's not even that great of a price....

 

What's wrong with blocks? i have used some in the past and didn't had any problem, actually, i like the fact that they turn the differential a bit to compensate drive shaft angle.....i know you lost some traction but i dont think is that bad....

 

Lol no

 

Those spindles are maxtrac. I love mine.

 

Raptors run blocks

 

The Spindles are good (I have them they are awesome) but not sure throught that vendor. These came up months ago and then a groupbuy was getting prepared for them. I believe "Lift USA" is a distributor, but the spindles are made by MaxTrac. Previous versions were slightly off from the cast, and an entre new version/set was made due to one TW member trying them out. Here was the original groupbuy.

http://www.tacomaworld.com/forum/gr...ke-lines-maxtrac-groupbuy-nov-3-nov-11-a.html


Main Thread about the MaxTrac spindles: (looks like currently out for couple months through couple vendors)
http://www.tacomaworld.com/forum/suspension/203889-maxtrac-spindle-lift-2nd-gen-prerunners.html

I'd stay away from blocks from what I've read/heard, but I'd definitely check out MaxTrac spindles. I got mine from Southland Motoring.